Production Process Of PFA Butterfly Valve

Apr 15, 2025

Leave a message

The production process of PFA butterfly valve mainly includes the following steps:

**Valve body casting:

Waxing workshop: Make the model and wax and cool it.

Shell making workshop: Use fine sand and coarse sand to make the shell.

Dewaxing, baking, casting, sand dropping (through sand), grinding and shot blasting.

**Valve body processing:

Valve body head processing, gate processing.

Drilling, reverse cutting.

Sealing surface rough turning.

Sealing surface surfacing (using wear-resistant and corrosion-resistant materials such as Steel, 2Cr13, D507Mo, 304, 316, etc.).

Valve body and diameter grinding.

Valve body sealing surface finishing.

Gate valve disc sealing surface rough turning.

Gate valve and disc finishing.
*‌*Valve cover bracket processing‌:

‌Ball valve flange and diameter processing‌.
‌Bracket middle head processing‌.
‌Bracket upper sealing thread processing‌.
‌Bracket packing and cap thread processing‌.
‌Bracket jack drilling‌.
‌**Accessories processing‌:

‌Forged round steel‌,‌annealing‌.
‌Upper seal, flying thread and wash opposite edge processing‌.
‌Polishing rod deburring‌.
‌Flat valve stem bottom processing‌.
‌Ball valve accessories processing‌ (such as adding PTFE pads and O-rings)‌.
*‌*Assembly pressure test‌:

‌Assembly bearing caps‌,‌throwing pins‌.
‌All handwheels are sprayed with plastic and painted‌.
‌Valve sealing test‌ to ensure that the design requirements are met‌.
‌**Finished product acceptance‌:

‌Appearance inspection‌ to ensure that the valve appearance meets the standards.
‌Functional test‌ to ensure that the valve operates normally‌.

Send Inquiry